RECYCLED CONCRETE AGGREGATE AS A REPLACEMENT FOR NATURAL COARSE AGGREGATE: PHYSICAL CHARACTERIZATION AND COMPRESSIVE STRENGTH OF NON-STRUCTURAL CONCRETES
DOI:
https://doi.org/10.66104/45s2g007Keywords:
recycled concrete aggregate, construction and demolition waste, aggregate characterization, compressive strength, non-structural concreteAbstract
Recycling concrete waste as coarse aggregate reduces the extraction of natural aggregates and the landfilling of construction and demolition waste (CDW). This study physically characterized a recycled concrete aggregate (RCA), obtained by crushing laboratory-tested concrete specimens, in comparison with a commercial crushed stone (brita 1), and evaluated the compressive strength of concretes produced with 50% and 100% replacement, by mass, of the natural aggregate by RCA. Surface morphology (digital microscopy), water absorption and oven-dry density (ABNT NBR 16917:2021), loose bulk density (ABNT NBR 16972:2021) and particle-size distribution (ABNT NBR 17054:2022) were determined, together with axial compressive strength at 7 and 28 days (ABNT NBR 5739:2018). The RCA showed a water absorption of 7.51%, against 3.04% for the natural crushed stone, a lower oven-dry density and a loose bulk density 8.6% lower (1,753 versus 1,918 kg/m³), all attributed to the mortar adhered to the particles. The maximum characteristic size of the RCA was 25 mm and its fineness modulus 6.43. The measured absorption exceeds the 7% limit set by ABNT NBR 15116:2021 for the ARCO class, which restricts the material to non-structural uses. Concretes with a 1:3:3 mix proportion by mass reached mean strengths of 6.29 ± 0.64 MPa (50%) and 6.83 ± 0.97 MPa (100%) at 28 days, with gains of 34% and 48% between 7 and 28 days. The 8.6% difference between mixes is smaller than the standard deviation of the groups and does not support attributing superiority to either replacement level. The results indicate the technical feasibility of the studied RCA for non-structural concrete products, provided that mix design accounts for the high aggregate absorption.Downloads
References
Almeida e Silva, Danillo de, e Carlos Eduardo Luna de Melo. “Agregado reciclado, uma fonte sustentável de matéria-prima: uma revisão.” Revista Principia, vol. 60, no. 1, 2023, https://doi.org/10.18265/1517-0306a2021id6033. DOI: https://doi.org/10.18265/1517-0306a2021id6033
Alves, Jordane Gabriele Santos, et al. “Concrete Waste as Coarse Aggregate in Cementitious Matrices: Review.” Mix Sustentável, vol. 10, no. 5, 2024, pp. 161-171, https://doi.org/10.29183/2447-3073.MIX2024.v10.n5.161-171. DOI: https://doi.org/10.29183/2447-3073.MIX2024.v10.n5.161-171
Angulo, Sérgio Cirelli, e Antonio Domingues de Figueiredo. “Concreto com agregado reciclado.” Concreto: Ciência e Tecnologia, organizado por Geraldo Cechella Isaia, vol. 2, IBRACON, 2011, cap. 47, pp. 1731-1767.
Associação Brasileira de Normas Técnicas. ABNT NBR 5738: Concreto – Procedimento para moldagem e cura de corpos de prova. ABNT, 2015.
---. ABNT NBR 5739: Concreto – Ensaio de compressão de corpos de prova cilíndricos. ABNT, 2018.
---. ABNT NBR 6136: Blocos vazados de concreto simples para alvenaria – Requisitos. ABNT, 2016.
---. ABNT NBR 7211: Agregados para concreto – Especificação. ABNT, 2019.
---. ABNT NBR 8953: Concreto para fins estruturais – Classificação pela massa específica, por grupos de resistência e consistência. ABNT, 2015.
---. ABNT NBR 12655: Concreto de cimento Portland – Preparo, controle, recebimento e aceitação – Procedimento. ABNT, 2022.
---. ABNT NBR 15116: Agregados reciclados para uso em argamassas e concretos de cimento Portland – Requisitos e métodos de ensaios. ABNT, 2021.
---. ABNT NBR 15844: Rochas para revestimento – Requisitos para granitos. ABNT, 2015.
---. ABNT NBR 16697: Cimento Portland – Requisitos. ABNT, 2018.
---. ABNT NBR 16889: Concreto – Determinação da consistência pelo abatimento do tronco de cone. ABNT, 2020.
---. ABNT NBR 16915: Agregados – Amostragem. ABNT, 2021.
---. ABNT NBR 16916: Agregado miúdo – Determinação da densidade e da absorção de água. ABNT, 2021.
---. ABNT NBR 16917: Agregado graúdo – Determinação da densidade e da absorção de água. ABNT, 2021.
---. ABNT NBR 16972: Agregados – Determinação da massa unitária e do índice de vazios. ABNT, 2021.
---. ABNT NBR 17054: Agregados – Determinação da composição granulométrica – Método de ensaio. ABNT, 2022.
Bauer, Luiz Alfredo Falcão. Materiais de Construção. 5ª ed., vol. 1, LTC, 2000.
Brasil. Conselho Nacional do Meio Ambiente. Resolução CONAMA nº 307, de 5 de julho de 2002. Estabelece diretrizes, critérios e procedimentos para a gestão dos resíduos da construção civil. Diário Oficial da União, 17 jul. 2002.
---. Resolução CONAMA nº 448, de 18 de janeiro de 2012. Altera os arts. 2º, 4º, 5º, 6º, 8º, 9º, 10 e 11 da Resolução nº 307/2002. Diário Oficial da União, 19 jan. 2012.
Brasil. Lei nº 12.305, de 2 de agosto de 2010. Institui a Política Nacional de Resíduos Sólidos. Diário Oficial da União, 3 ago. 2010, www.planalto.gov.br/ccivil_03/_ato2007-2010/2010/lei/l12305.htm.
Cabral, Antonio Eduardo Bezerra, et al. “Mechanical Properties Modeling of Recycled Aggregate Concrete.” Construction and Building Materials, vol. 24, no. 4, 2010, pp. 421-430, https://doi.org/10.1016/j.conbuildmat.2009.10.011. DOI: https://doi.org/10.1016/j.conbuildmat.2009.10.011
Cangussu, Nayara, et al. “Influence of the Preparation of the Cylindrical Specimen Surface and Approach Analysis on the Test Value of Compressive Strength.” Structural Concrete, vol. 23, no. 6, 2022, pp. 3722-3736, https://doi.org/10.1002/suco.202100636. DOI: https://doi.org/10.1002/suco.202100761
Carvalho, R. A., et al. “Utilização de resíduos de corpos de prova de concreto para fabricação de pavimentação intertravada.” Revista UNIFAE, vol. 6, no. 2, 2018, pp. 12-26. DOI: https://doi.org/10.26843/interscientia.v6i2.872
Etxeberria, Miren, et al. “Influence of Amount of Recycled Coarse Aggregates and Production Process on Properties of Recycled Aggregate Concrete.” Cement and Concrete Research, vol. 37, no. 5, 2007, pp. 735-742, https://doi.org/10.1016/j.cemconres.2007.02.002. DOI: https://doi.org/10.1016/j.cemconres.2007.02.002
Frotté, Camila, et al. “Estudo das propriedades físicas e mecânicas de concreto com substituição parcial de agregado natural por agregado reciclado proveniente de RCD.” Matéria (Rio de Janeiro), vol. 22, no. 2, 2017, https://doi.org/10.1590/S1517-707620170002.0143. DOI: https://doi.org/10.1590/s1517-707620170002.0143
Gomes, Henrique C. “Concreto produzido com resíduos de construção e demolição.” Anais do IX Encontro Nacional de Aproveitamento de Resíduos na Construção (ENARC), vol. 9, no. 1, ANTAC, 2025, pp. 1-6, https://doi.org/10.46421/enarc.v9i1.6673. DOI: https://doi.org/10.46421/enarc.v9i1.6673
Leite, Mônica Batista. Avaliação de propriedades mecânicas de concretos produzidos com agregados reciclados de resíduos de construção e demolição. 2001. Universidade Federal do Rio Grande do Sul, tese de doutorado, www.lume.ufrgs.br/handle/10183/21839.
Levy, Salomon Mony. Contribuição ao estudo da durabilidade de concretos produzidos com resíduos de concreto e alvenaria. 2001. Universidade de São Paulo, tese de doutorado.
Mehta, P. Kumar, e Paulo J. M. Monteiro. Concreto: Microestrutura, Propriedades e Materiais. 2ª ed. brasileira, IBRACON, 2014.
Nagataki, Shigeyoshi, et al. “Assessment of Recycling Process Induced Damage Sensitivity of Recycled Concrete Aggregates.” Cement and Concrete Research, vol. 34, no. 6, 2004, pp. 965-971, https://doi.org/10.1016/j.cemconres.2003.11.008. DOI: https://doi.org/10.1016/j.cemconres.2003.11.008
Neville, Adam M. Propriedades do Concreto. 5ª ed., Bookman, 2016.
Poon, Chi Sun, Z. H. Shui e L. Lam. “Effect of Microstructure of ITZ on Compressive Strength of Concrete Prepared with Recycled Aggregates.” Construction and Building Materials, vol. 18, no. 6, 2004, pp. 461-468, https://doi.org/10.1016/j.conbuildmat.2004.03.005. DOI: https://doi.org/10.1016/j.conbuildmat.2004.03.005
Santos, S. B. J. S., et al. “Utilização de resíduos de corpos de prova em substituição do agregado graúdo de concretos.” Revista InterScientia, vol. 4, no. 2, 2016, pp. 137-151.
Silva, Rui Vasco, Jorge de Brito e Ravindra K. Dhir. “Properties and Composition of Recycled Aggregates from Construction and Demolition Waste Suitable for Concrete Production.” Construction and Building Materials, vol. 65, 2014, pp. 201-217, https://doi.org/10.1016/j.conbuildmat.2014.04.117. DOI: https://doi.org/10.1016/j.conbuildmat.2014.04.117
Surya, M., V. V. L. Kanta Rao e P. Lakshmy. “Recycled Aggregate Concrete for Transportation Infrastructure.” Procedia – Social and Behavioral Sciences, vol. 104, 2013, pp. 1158-1167, https://doi.org/10.1016/j.sbspro.2013.11.212. DOI: https://doi.org/10.1016/j.sbspro.2013.11.212
Tam, Vivian W. Y., Mahfooz Soomro e Ana Catarina Jorge Evangelista. “A Review of Recycled Aggregate in Concrete Applications (2000-2017).” Construction and Building Materials, vol. 172, 2018, pp. 272-292, https://doi.org/10.1016/j.conbuildmat.2018.03.240. DOI: https://doi.org/10.1016/j.conbuildmat.2018.03.240
Tenório, Jonathas J. L., et al. “Concrete Produced with Recycled Aggregates.” Revista IBRACON de Estruturas e Materiais, vol. 5, no. 5, 2012, pp. 692-701, https://doi.org/10.1590/S1983-41952012000500006. DOI: https://doi.org/10.1590/S1983-41952012000500006
Published
Issue
Section
License
Copyright (c) 2026 Me. Adalto Soares da Fonseca Júnior, Dr. Álvaro Barbosa de Carvalho Júnior, Leticia Cardoso Batista, Kaio Rocha Souza, Thais Soares Ribeiro, Me Ana Carolina Nery Munoz Carvalho, Hivanna Prates Duarte

This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish in this journal agree to the following terms:
Authors retain copyright and grant the journal the right of first publication, with the work simultaneously licensed under the Creative Commons Attribution License, which permits the sharing of the work with proper acknowledgment of authorship and initial publication in this journal;
Authors are authorized to enter into separate, additional agreements for the non-exclusive distribution of the version of the work published in this journal (e.g., posting in an institutional repository or publishing it as a book chapter), provided that authorship and initial publication in this journal are properly acknowledged, and that the work is adapted to the template of the respective repository;
Authors are permitted and encouraged to post and distribute their work online (e.g., in institutional repositories or on their personal websites) at any point before or during the editorial process, as this may lead to productive exchanges and increase the impact and citation of the published work (see The Effect of Open Access);
Authors are responsible for correctly providing their personal information, including name, keywords, abstracts, and other relevant data, thereby defining how they wish to be cited. The journal’s editorial board is not responsible for any errors or inconsistencies in these records.
PRIVACY POLICY
The names and email addresses provided to this journal will be used exclusively for the purposes of this publication and will not be made available for any other purpose or to third parties.
Note: All content of the work is the sole responsibility of the author and the advisor.
